Plastic - Импорт экспорт

Artificial plastic teeth Estedent-02 are designed for application in prosthodontics for manufacturing of remov­able denture constructions. Plastic teeth Estedent-02 are manufactured on base of cross-linked acrylic polymers. They have a fluorescent effect (teeth put into partial denture look harmoniously near natured teeth in ultra-violet rays). Teeth Estedent-02 have a good chemical binding with denture base. Like their natural prototype teeth Estedent- 02 have optimal functional and cosmetic characteristics. Teeth Estedent-02 are manufactured in accordance with “Vita” scale and consist of 9 shades: A2; A3; A3.5; B2; B3; C2; C3; D2; D3. Due coloring scale Estedent-03 teeth comply with colors № 28, 32, 33, 34, 35, 36, 38, 40, 41.

Indications for use: manufacturing of temporary plate-type removable dentures; repair and restoration of removable dentures; maxillofacial appliances; orthodontic appliances; manufacturing of removable prosthetic splints; Strong points: multipurpose use; rapid guaranteed polymerization; beneficial cosmetic effect due to denture translucency and introduction in material of "streaks" that imitate soft tissues of oral cavity; good workability of products; Application instructions: mix-up powder and liquid in a 2:1 ratio; carry out the process of polymerization at room temperature in a heating cabinet at 35-45°C for 25-30 minutes; treat and polish the material by conventional methods;

Indications for use: manufacturing of complete upper- and lower jaw dentures; manufacturing of partial dentures; Strong points: high accuracy shape reproduction; high ultimate flexural strength; optimal elasticity; beneficial cosmetic effect due to denture translucency and introduction of «streaks» that imitate the soft tissues of the oral cavity; good polishing ability; Application instructions: mix powder with liquid in 2:1 ratio; plastic modeling phase is about 20 minutes; carry out the polymerization process in a water bath in dental flasks, by bringing the water bath to boiling point gradually within 40-50 minutes; polymerization process takes 30 minutes; do not retrieve the denture from the flask until it is cooled down completely;

Our Own Production Introducing the rectangular internal end cap for profile tubes – a high-quality product from our own manufacturing. We take pride in manufacturing the entire process at our facility, allowing us to control quality at every stage of production. Environmental Responsibility We care about the environment, which is why we use recycled materials to produce our end caps. By choosing our product, you support ecological initiatives and contribute to reducing waste. Product Features: Material: High-quality recycled plastic Shape: Rectangular Purpose: For internal sealing of profile tubes Sizes: Available in various sizes to fit a wide range of profile tubes Durability: High strength and resistance to external influences Order now and support eco-friendly production!

Our Own Production Introducing the square internal end cap for profile tubes – a high-quality product from our own manufacturing. We are proud that the entire production process takes place at our facility, allowing us to control the quality at every stage of production. Environmental Responsibility We care about the environment, which is why we use recycled materials to produce our end caps. By choosing our product, you support ecological initiatives and contribute to reducing waste. Product Features: Material: High-quality recycled plastic Shape: Square Purpose: For internal sealing of profile tubes Sizes: Available in various sizes to fit a wide range of profile tubes Durability: High strength and resistance to external influences Order now and support eco-friendly production!